trinityamps.com

Trinity Amps Guitar Amp Forum
It is currently Thu Oct 31, 2024 7:27 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Sat Nov 01, 2014 9:44 pm 
Offline

Joined: Thu Jun 26, 2014 4:17 pm
Posts: 8
Hey guys,

Sent an email earlier today to Stephen as well, but thought I'd try here too.

On the layout, for the input jacks, it shows the 1 mega-ohm resistors connected between the "hot" lug and the "switch" lug. Now, I know those resistors get moved down to be soldered to pins 2 and 7 on V1, and to ground. But... again, looking at the layout, at the input jacks, there is a short going between the "switch" lug and the "ground" lug for the Hi input jacks. Does that short stay, or does it get removed?

Thanks in advance for any help you all can provide!
Tom


Top
 Profile  
 
PostPosted: Sat Nov 01, 2014 11:53 pm 
Offline
Expert
Expert

Joined: Sat Dec 04, 2010 3:42 pm
Posts: 519
Location: Qualicum Beach, BC
The "shorts" you mentioned stay. The hot terminals must be grounded if nothing is plugged into the jacks.


Top
 Profile  
 
PostPosted: Sun Nov 02, 2014 2:36 am 
Offline

Joined: Thu Jun 26, 2014 4:17 pm
Posts: 8
Thanks mitch. Yes, Stephen also replied to my email with the same info.

Finished up my Tweed 5E3 tonight, and it sounds great! Couldn't crank it up yet (kids/wife in bed), but that shall come tomorrow. Or later today, as it's after midnight here. :)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 21 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group