trinityamps.com

Trinity Amps Guitar Amp Forum
It is currently Sat Jun 22, 2024 6:28 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
 Post subject: B15 build questions
PostPosted: Thu Jul 28, 2022 4:25 am 
Offline

Joined: Thu Jul 28, 2022 4:12 am
Posts: 1
Hey Stephen

I built the heritage B15, but added your heater elevation circuit before the 1st filter stage of the Ampeg circuit. The amp runs great, but I have a stubborn hum that can only be eliminated by turning the humpot really off centre. I get 1.4V at one side and 4.8V at the other side.
Do you connect your HT CT at the negative side of C21 ?

At the Hoffman site people advise against heater elevation and I argued that. I told that you must have implemented it for some reason and that I trust your expertise on this. Mainly because the 2x 47uf 450V series filtercaps seem more reliable than one 50uf 500V on the Ampeg. Could you shed a light on why you decided to do the heater elevation? Thanks

Also.. Ampeg has only one ground point whereas you and all 18W circuits have 2. I did the 2 ground circuit.. one for preamp and one for all others. It has always worked super for me. Why would Ampeg do it the other way? Any ideas?
Thanks

Bjorn


Top
 Profile  
 
 Post subject: Re: B15 build questions
PostPosted: Sun Mar 17, 2024 9:54 pm 
Offline

Joined: Sun Mar 17, 2024 9:52 pm
Posts: 1
I appreciate you sharing this fantastic post. Thank you so much for sharing this content; I really loved reading it.
penalty shooters 2


Top
 Profile  
 
 Post subject: Re: B15 build questions
PostPosted: Fri Apr 05, 2024 5:46 am 
Offline

Joined: Fri Apr 05, 2024 5:40 am
Posts: 1
You should check to see why there is a stubborn humming sound in the Amplifier. It may be due to incorrect installation using the 2x 47uf 450V line filter cap.

geometry dash subzero


Top
 Profile  
 
 Post subject: Re: B15 build questions
PostPosted: Sun Apr 21, 2024 11:30 pm 
Offline

Joined: Mon Aug 14, 2023 4:52 am
Posts: 3
While both approaches can be effective, it's essential to ensure proper grounding techniques are followed to maintain signal integrity and minimize noise.strands


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group