trinityamps.com

So I am trying to get my old kit working. I have traced down that one of my jumper wires wasn’t sending voltage. It is now working and I am getting correct voltages everywhere except on v5 and v6 I am getting roughly 120v instead of 242 on pin 9. I am wondering if the resistor that I have wired in off the b+ voltage is incorrect. I am getting no sound out of the amp. Some popping and clicking when I turn the contour switch/plug in and unplug the 1/4 in jack. Tubes all heat up. What do you guys think is my issue in my guitar signal wiring and what should I check?

V1
Pin 1: 81
Pin 3: 1.94
Pin 6: 128
Pin 8: 1.94

V2
Pin 1: 143
Pin 3: 1.29
Pin 6: 144
Pin 8: 1.29

V3
Pin 1: 173
Pin 3: 1.22
Pin 6: 268
Pin 8: 172

V4
Pin 1: 213
Pin 2: 22
Pin 3: 49
Pin 6: 330
Pin 7: 45
Pin 8: 66

V5
Pin 3: 3.63
Pin 7: 383
Pin 9: 117

V6
Pin 3: 3.63
Pin 7: 380
Pin 9: 117

V7
Pin 8: 385

I have verified that the resistor that feeds the irregular voltages on v5 & v6 is correct according to documentation.