coco wrote:
AC volts measured across the 2 red wires on the board?
AC to ground on each
coco wrote:
DC voltage measured from any diode to ground and at the junction? the reason they are daisy chained is for safety factor is all.
AC to ground, just trying to find where the problem comes from. Where the 2 diodes connect I get 0 volts.
coco wrote:
Is there a 500 ma fuse in the HV fuse holder?
Yes. Fuses in and also swapped out with new ones just in case. If I check continuity across the fuse we are good. I’ve check the whole circuit for continuity, seems good. Triple checked against the layout and schematic.
coco wrote:
If the standby is off, the fIlter caps are not in circuit yet so not part of the equation.
Standby is on. I even tried tubes in it and get very low volume and farty sounds when I play.
Totally at a loss here what might be going on.
Thanks for the response.