trinityamps.com

Trinity Amps Guitar Amp Forum
It is currently Thu Oct 31, 2024 7:48 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Wed Mar 14, 2018 6:48 pm 
Offline

Joined: Sat Mar 10, 2018 1:48 pm
Posts: 8
I'm sure this is a dumb question, but pg.35 of the Trinity Tweed manual references a "white wire" from the transformer. I don't see one. I have a blue/black wire and a black wire, but not "third" white wire. Am I just mis-reading the instructions?

I have the eyelet board and OT wired, but I am nervous about testing the PT because of the above issue. Anyone know what I'm talking about?

I'll attempt to post pictures...


Attachments:
power transformer.jpg
power transformer.jpg [ 827.88 KiB | Viewed 6475 times ]
File comment: eyelet board
IMG_0040.JPG
IMG_0040.JPG [ 5.1 MiB | Viewed 6474 times ]
OT.jpg
OT.jpg [ 718.61 KiB | Viewed 6474 times ]
Top
 Profile  
 
PostPosted: Thu Mar 15, 2018 7:56 pm 
Offline
Experienced
Experienced
User avatar

Joined: Wed Aug 26, 2009 11:27 pm
Posts: 273
Location: Ontario
If you look at the layout in the resource section before the IEC connector was in use. There would have been a white neutral wire coming from the bare power cable that was just held in a pinch connector in the chassis . Thats the white wire that would have been connected to the black/black and black/blue wire from the transformer .

in your case that black/black and black/blue just go to the neutral pin of the IEC. . I assume its 120v. . wiring

don't know why in the doc it another wire soldered to the IEC then connected to black/black and black/blue. Maybe a proper colour code for IEC connection


Top
 Profile  
 
PostPosted: Fri Mar 16, 2018 9:55 am 
Offline

Joined: Sat Mar 10, 2018 1:48 pm
Posts: 8
Thanks, I think I got it! I appreciate your reply.


Top
 Profile  
 
PostPosted: Sat Apr 14, 2018 3:30 pm 
Offline
Holy Ghost
Holy Ghost
User avatar

Joined: Sun Mar 13, 2005 4:10 pm
Posts: 7519
Location: Canada
Correct mitch - the manual says "The other side of the IEC socket needs a White or ‘Neutral’ wire that gets routed and soldered to the ‘Common’ side of the power transformer". you need to connct one from the IEC to the Tx wires.
Then "Twist the Black-Blue & Black wires together. Slip some heat shrink tubing over the White neutral wire. "

_________________
Stephen
Web: www.trinityamps.com. Facebook: facebook.com/trinityamps. Twitter: @trinityamps


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 17 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group